Microchip Technology TC4423CPA

Gate Drivers ICs Through Hole Tube Active Gate Drivers ICs EAR99

the maximum body temperature at which the thermistor is designed to operate for extended periods of time with acceptable stability of its electrical characteristics.

The operating temperature is the range of ambient temperature within which a power supply, or any other electrical equipment, operate in. This ranges from a minimum operating temperature, to a peak or maximum operating temperature, outside which, the power supply may fail.

Semiconductor package is a carrier / shell used to contain and cover one or more semiconductor components or integrated circuits. The material of the shell can be metal, plastic, glass or ceramic.

Parts can have many statuses as they progress through the configuration, analysis, review, and approval stages.

The Maximum Operating Temperature is the maximum body temperature at which the thermistor is designed to operate for extended periods of time with acceptable stability of its electrical characteristics.

The maximum power that the MOSFET can dissipate continuously under the specified thermal conditions.

a count of all of the component leads (or pins)

The maximum current that can be supplied to the load.

The voltage level by which an electrical system is designated and to which certain operating characteristics of the system are related.

In general, the absolute maximum common-mode voltage is VEE-0.3V and VCC+0.3V, but for products without a protection element at the VCC side, voltages up to the absolute maximum rated supply voltage (i.e. VEE+36V) can be supplied, regardless of supply voltage.

The minimum supply voltage (V min ) is explored for sequential logic circuits by statistically simulating the impact of within-die process variations and gate-dielectric soft breakdown on data retention and hold time.

Nominal current is the same as the rated current. It is the current drawn by the motor while delivering rated mechanical output at its shaft.

the process by which an electronic or electrical device produces heat (energy loss or waste) as an undesirable derivative of its primary action.

The rated output current is the maximum load current that a power supply can provide at a specified ambient temperature. A power supply can never provide more current that it's rated output current unless there is a fault, such as short circuit at the load.

the flight time of packets over the transmission link and is limited by the speed of light.

Turn-on delay, td(on), is the time taken to charge the input capacitance of the device before drain current conduction can start.

In electronics, when describing a voltage or current step function, rise time is the time taken by a signal to change from a specified low value to a specified high value.

a group of products which fulfill a similar need for a market segment or market as a whole.

The time that it takes a gate circuit to allow a current to reach its full value.

a particular group of related products.

Radiation hardening is the process of making electronic components and circuits resistant to damage or malfunction caused by high levels of ionizing radiation, especially for environments in outer space (especially beyond the low Earth orbit), around nuclear reactors and particle accelerators, or during nuclear accidents or nuclear warfare.

RoHS means “Restriction of Certain Hazardous Substances” in the “Hazardous Substances Directive” in electrical and electronic equipment.